Check the V + signaling pathways Pa Ic to make sure that this path semuan normal. 2. Rehoot filters the signal on the side of the IC PA nokia 105, try rehoot if the wind is not too hot because it can cause more severe problems. 3. If the first and the second step is not successful then the damage is definitely there in Ic Power.
#nokia105headphoneways #nokiata1010headphonenotworkingsubscribe our channel for more videosthanks for watching
Nokia C1-01 Light Solution Problem Repairing Solutions are available in the following article. Nokia C1-01 Led Light Ways and Jumpers information can also be found in the diagrams further in this post. In Nokia C1-01 Light Solution Problem can occur because of the faulty Lights IC or it’s bad connection to the Cell Phone’s Motherboard.Nokia 105 Handsfree Activated. Nokia 105 Handsfree Solution Activated problem can occur because of the faulty Handsfree Connector or it’s bad connection to the Cell Phone’s Motherboard. So first of all you should clean Nokia 105 Handsfree Connector Ways and. In the Following Article We Explained Nokia 105 Handsfree (Headset mode ) Activated Nokia 105 RM-1134 Handsfree Mode Problem Solution: Clean Nokia 105 RM-1134 Audio jack contacts with the help of cotton cloth and check. Re-solder all the pins of Audio Jack and check, as sometimes it becomes dry solder or soldering comes off due to any kind of physical damage. Also, check for traces of water damage and clean it.
nokia 101 local mode solution Is Not Working Repairing Diagram Easy Steps to Solve Full Tested.BUY LINK -https://amzn.to/2raFAc6BUY LINK -http://fkrt.it/CFM~
Nokia 6030 Local Mode Test Mode Local Mode Problem Test Mode Problem Local Mode Solution Test Mode Solution September 29, 2008 by admin · Published September 29, 2008 · Last modified September 29, 2015
To remove local mode in nokia 1280.Please fallow the instructions. 1.change or remove the buuble near the the main ic 2,you cannot do this own. 3.contact your mobile service center.
step 1# your phone has this problem then first clean full pcb and hit with Stan-light then see result if you see result same then apply 2step. step 2# If not success using one step solution then remove red mark parts.I hope your problem will be solve. Email ThisBlogThis!Share to TwitterShare to FacebookShare to Pinterest.
